TOS Personnel Training Record and Practical Sign Off

General Information

Name

Date

Previous Training and Experience

If the worker has previous experience or training on a similar type of equipment and demonstrates their abilities to the satisfaction of the person directing the training, some of the previous experience may be used to meet the requirements of the training program. (See Table 11 (II) Saskatchewan OHS Regulations 2020.)

Worker's Initials

Previous Hours

Theory Training

Date

Location

Online

Yes No

Score

Pass/Fail

Pass Fail

Details

Theory Hours

Engine Start Up

Locate master switch Ensure park brake is applied Proper position of controls to start up Know purpose of all controls Proper starting of engine Turn over time not to exceed 15 seconds Allow engine to warm up before operating at full RPM

Operational Checks

Employee completes appropriate area checks before putting unit into service Employee checks for people/hazards/equipment before putting vehicle into motion Employee operates unit at appropriate speed for road/hazard conditions Travel on level ground whenever possible Never turn sharply at high speeds Watch overhead clearance Yield for oncoming traffic and intersections Do not overload, know weight of load

Shut Down

Bring to stop, apply emergency brake Wheel turned toward wall Park vehicle on level ground (preferred) Park away from bad ground Turn off key switch and lights Turn off master switch Double chock wheels Housekeeping/remove debris

Major Problems

Fill out logbook Report to your supervisor

Practical Training

Name

Date

Location U/G

Pass/Fail

Pass Fail

Describe operator pre-op

Describe operator demonstration

Describe operator shutdown

Practical Hours

Total Training Hours

A worker who has completed a minimum of 16 Total Training Hours and has achieved a passing grade on his practical skills training component is considered a competent operator of the equipment and may operate it as such. Workers with fewer than 16 hours may only operate under the supervision of a competent operator.

Total Training Hours

Operator Declaration

I have reviewed this document and find it to be an accurate description of my training and experience on this equipment.

Operator Signature

Date

Trainer Declaration

The operator indicated on this training record:

Has demonstrated competence on this equipment and may operate the equipment as a competent operator May operate the equipment under the supervision of a competent operator only at this time

Trainer/Supervisor Signature

Date

TOS Personnel Training Record and Practical Sign Off

General Information

Previous Training and Experience

Theory Training

Pre-Checks

Engine Start Up

Engine Running Checks

Operational Checks

Shut Down

Major Problems

Practical Training

Total Training Hours

Operator Declaration

Trainer Declaration